Bronkhorst
Application note

Aeration in fish farming

Our Norwegian distributor, Flow-Teknikk, assisted a customer involved in the oxygenation of salmon in open sea fish farming cages with an aeration solution containing automated and remotely controlled air flow controllers.

Aeration: supply of oxygen to water

Fish farming inside the Norwegian fjords is characterised by less circulation of water and warmer temperatures. Fjords protect the fish farms from excessive wave movements, but also provide ideal conditions for unwanted fish lice. To prevent fish lice and other diseases on these farms, aeration into the fish cages is essential. Aeration, also called oxygenation, is the supply of oxygen to water. This can be done with air flow controller.

Check out the Bronkhorst solution
Flow controllers for Fish farming application

Application requirements

The aeration into the fish cages needs to be automated and remotely controlled from one computer. This control function is not just for on/off setting, but should be able to fine-tune the air flow for optimal aeration. 

Important topics

  • Automation and remote control
  • Economic, robust solution


Air flow controllers for aeration

Process solution

A set of multiple Bronkhorst MASS-STREAM™ D-6371 mass flow controllers is applied for the aeration, with one device for each fish cage. Each air flow controller supplies air in a range between 250 and 600 liters per minute. The air comes from a compressor and enters the flow instrument at a pressure of 6 bars.

The flow controllers are remotely controlled from a custom made human machine interface (HMI) on the customer's computer, using a PLC and the Modbus communication protocol. This computer is located in a command centre on land, and signals are sent via a mobile 4G network to a feeding raft in the sea between the fjords close to the cages. The compressor is located in the belly of the feeding raft, and the cabinet with the air flow controllers is on deck. The remote control from the command centre allows stopping aeration when they feed the fish, meaning that the people who control the feeding can also control aeration. This is a big step forward. Normally, they don’t want to use aeration at the same time as they are feeding.

Flow scheme
Flow scheme

Prior to the Bronkhorst solution, the fish farmer used variable area flow meters (VA meters) in combination with manual needle valves at the site. To comply with the automation and remotely control requests of the customers, the pilot setup was executed with FLOW-BUS communication protocol. To be able to customise temperature and pressure reading, the final setup was executed with Modbus. Due to the digital electronics on the MASS-STREAM devices, it was possible to upgrade the firmware with Modbus.

An important reason for the customer to use the MASS-STREAM flow controllers is their good price-performance ratio. As the company needed multiple instruments for this application, this was an important aspect. Moreover, the integrated display on each of the devices allows to locally override the remote settings, if needed. On top of that, the robust design with direct through-flow measurement based on the Constant Temperature Anemometer (CTA) principle is favourable in the demanding Norwegian surroundings. 

Fish lice in a fishing farm can have a devastating effect for a farming company. As fish lice treatment is very expensive and time consuming, preventing the occurrence of fish lice by means as aeration is extremely cost reducing. 

Ask advice Check the recommended products

Fish farming application
Aeartion in fish farming
Flow controllers for fish farming application


台灣柏朗豪斯特股份有限公司

新竹縣竹北市台元街三十八號四樓之一、二
Rm. 1 & 2, 4F., No.38, Taiyuan St., Zhubei City, Hsinchu County 302, Taiwan (R.O.C.)
電話 +886 3-5600-518
[email protected]

            Social Responsibility
Copyright © 2024 Bronkhorst. All rights reserved.     Sitemap     Disclaimer     Privacy note